01384 401688

Lithofin KF Stainstop 500ml ceramic and quarry tile sealer

OUR PRICE: £24.26
Stock Status: In Stock
Product Code: 9.65
You Will Earn 24 points which is the equivalent of £0.48

Lithofin KF Stainstop 500ml ceramic and quarry tile sealer


A special product from the LITHOFIN-Range for ceramic and

quarry tiles (KF). This ready-to-use special impregnator is

solvent based and contains high quality water and oil resistant


Technical Data:

Density: approx. 0,78 g/cm³

Appearance: liquid, colourless, clear

Odour: aromatic

pH-Value: n.a.

Flash Point: approx. 23°C

Reduction in Water Absorption: 90 to 95%


Lithofin KF Stain-Stop penetrates into the surface and coats the

capillaries with an extremely thin, invisible film. Oil, grease and

water are not absorbed by the surface, but instead remain on

the surface. During this time, dirt can easily be removed without

leaving stains. The effectiveness depends on the amount of

product absorbed by the surface.

The characteristic appearance of the surface material is not

or only slightly altered.

Field of Use:

For protecting unglazed ceramics against stains and for

facilitating every-day maintenance. Highly recommended for

use in kitchens, bathrooms and other areas which may come

into contact with water and oil.

Please Note: Lithofin KF Stain-Stop does not or only slightly

affect the slip resistance properties of the surface.

Directions for Use:

The surface to be treated must be completely dry and clean.

Always test the product in an inconspicuous area prior to use.

Areas should be treated in sections of approx. 10 to 15m².

On highly absorbent surfaces: evenly and generously apply

Lithofin KF Stain-Stop with a brush or roller. Avoid foam.

On less absorbent surfaces: use a brush or a cloth.

After approx. 20 minutes, apply Lithofin KF Stain-Stop again

to ensure that the entire surface is saturated. Then carefully

remove all surface residues with a cloth. On large areas use

a polishing machine with a white pad.

Do not allow any product to dry on the surface.

On highly absorbent surfaces, a second application after

approx. 24 hours may be necessary.

Attention! the liquid product must sink into the surface.

Do not allow the product to dry on the surface.

Dry residues will not be removable once product is fully cured.

Always try the product in an inconspicuous area prior to use.

Lithofin KF Stain-Stop can only be used on absorbent and

completely dry surfaces. Glass, ceramics, wood, and other

surfaces sensitive to solvents must be protected against


Application Temperature:

the temperature of the surface

should be between 5°C and 25°C.

Switch off under floor heating.

Drying Time: most solvents will evaporate within two hours.

The product will be fully effective after approx. 48 hours.

Coverage: depends on the absorbency of the material.

Estimates: clay slabs: 4 to 8m²/litre

unglazed quarry tiles: 8 to 12m²/litre


3 to 5 years in outdoor areas. Indoors, the durability

depends on the care products used. Strong de-greasing or

layer forming products are not suitable. For regular

maintenance, we recommend Lithofin KF Easy-Care.

Please note: We ship via APC as it is illegal to send hazardous materials through Royal Mail. So our postage charges may appear more than some of our competitors who do not have relevant insurance and carriers in place.

Customer Reviews
Write an online review and share your thoughts with other shoppers!