ORDER BY PHONE

01384 401688

Lithofin MN StainStop 1L Stone/Marble Sealer

OUR PRICE: £34.95
Stock Status: In Stock
Product Code: 18.51
You Will Earn 34 points which is the equivalent of £0.68
  • DESCRIPTION
  • REVIEWS

Lithofin MN Stain Stop 1L For Marble and Natural and Engineered Stone.

Coverage: approx. 7-15m²/L

Description

A special product from the LITHOFIN-Range for marble,

natural and engineered stone (MN).

Lithofin MN Stain-Stop contains high quality water and oil

resistant components based on alkoxysilanes.

Properties

Lithofin MN Stain-Stop penetrates into the surface and coats

the capillaries with an extremely thin, invisible film.

Oil, grease and water are not absorbed by the surface,

but remain on the surface (12 to 36 hours on polished marble

and limestone, up to 48 hours on granite and gneiss).

During this time, oil can easily be removed without leaving

stains. The effectiveness depends on the amount of product

absorbed by the surface. The appearance of the natural stone

is not affected. Some stones may become slightly darker in

colour. The water absorbency of the stone is greatly reduced;

the water permeability is only slightly affected. The product is

UV-resistant and does not yellow.

Field of Use

For invisible protection against staining and for facilitating

maintenance of all natural stone surfaces, including polished

marble. Perfect for use on wall and floor surfaces in the kitchen

and bathroom, as well as on table tops, window sills and other

sensitive surfaces.

Please Note: marble and limestone will remain sensitive to acid.

Directions for Use

Without prior experience or in cases of doubt, try the product

in an inconspicuous area prior to use. The surface to be treated

must be completely dry and clean.

Working in small areas (10 to 15m²) apply product

generously and evenly until the surface appears wet.

On dense stones: keep wet between 5 and 15 minutes and

ensure even distribution. Completely remove all excess – do

not allow to dry on the surface if not being absorbed into the

stone.

On highly absorbent stones: keep wet between 5 to 15 minutes

and ensure even distribution. After 1 hour repeat the process.

Completely remove all excess – do not allow to dry on the

surface if not being absorbed into the stone.

Immediately check the whole surface for an even finish. Allow

to dry for 1 to 2 hours.

Attention! the liquid product must sink into the stone. Do not

allow the product to dry on the surface. Wipe excess product

within 15 min.

Please Note: Non-absorbent surfaces cannot be impregnated.

Glass, ceramics, wood, and other surfaces sensitive to solvents

must be protected against splashes.

Application Temperature: the temperature of the surface should

be between 10°C and 25°C. Switch off under floor heating.

Drying Time: After 30-40 min. surface will be dry and ready to

be stepped on. Complete drying process and effectiveness of

the impregnation will take approx. 5 days. During this time, do

not cover the surface and wipe up any spills immediately.

Coverage: depends on the absorbency of the stone.

Estimates: polished surfaces: 12 to 25m²/litre

rough/honed granite: approx. 5-7m²/litre

porous sandstone: approx. 3-6 m²/litre


Customer Reviews
Write an online review and share your thoughts with other shoppers!