Product Code: 5.95
Lithofin MN Stain-Stop >ECO< 1l
DescriptionThis ready-to-use special impregnator is water based andnearly odourless. Highly active water and oil repellent polymersensure that this easy to apply treatment offers optimal results.Lithofin MN Stain-Stop >ECO< provides the ultimate protectionagainst water and oil stains and facilitates every-daymaintenance.Technical Data:Density: approx. 1.0 g/cm³ pH-Value: approx. 8Appearance: clear, yellowish, liquidOdour: nearly odourless Flash Point: n.a.
PropertiesLithofin MN Stain-Stop >ECO< penetrates into absorbentnatural stone surfaces and coats the capillaries with anextremely thin and invisible film of polymers. The treatmentprevents the immediate penetration of water based dirt as wellas oil and grease, and it provides an effective protection againststaining.This protective impregnator does not alter a stone’s sensitivityto acids.Durability: approx. four years depending on the type and use ofthe treated material and maintenance regime.
Field of UseTo protect absorbent natural stone against staining and torender surfaces water and oil repellent. Treatment isrecommended for all stone surfaces, such as: floors in kitchen,dining and living areas. The surfaces can be polished, honed,or rough. Lithofin MN Stain-Stop >ECO< can be used as initialprotection before grouting and as a pre-treatment. Suitable forindoor and outdoor use.Surfaces: absorbent natural stones, especially suitable forrough and honed limestone (e.g. Mocca Creme, Cabouca andsimilar materials).Please Note: on siliceous stones with a rough surface (such ashoned or flamed granite), dense limestone and in cases wherethe highest level of water repellency is required (eg. in theshower) we recommend using Lithofin MN Stain-Stop (solventbased). This also applies to surfaces that have been pre-treatedwith other impregnators or resins.
Directions for UseCheck the suitability and effect with a test in an inconspicuousarea or on a spare tile. The surface must be absorbent,completely dry, clean and free of stains. Shake bottle beforeuse.Apply generously and evenly using a lambswool applicator,roller, lint free cloth or sponge. Ensure even distribution bywiping over several times. Make a second application afterapprox. two hours.Ensure that all surface residues are removed after 15 mins bytowelling them off, do not allow residues to dry on the surface.On highly absorbent surfaces, apply product several times. Donot wait for surface to dry in between these applications.Check the surface for an even finish after the last application.Drying Time: approx. 3 hours. Treatment is fully effective after48 hours. Do not cover surface before then and wipe up anyspills immediately.
Please Note: some materials may appear slightly darker aftertreatment. If no prior product experience exists or in cases ofdoubt, we recommend a trial application. Immediately removesplashes on wood, glass, PVC, lacquered surfaces, etc. with adamp cloth. Clean application tools with water after use.Application Temperature: The temperature of the surface to betreated should not be under 10°C and not over 25°C. Turn offfloor heating.
Coverage: honed limestone: 4-8m² per litre, polished naturalstone: up to 20m².
Write an online review and share your thoughts with other shoppers!